Troubleshooting - Omron HV-F128 Instruction Manual

Tens therapy device electronic nerve stimulator

Hide thumbs Also See for HV-F128:

Instruction manual (24 pages)

Instruction manual (48 pages)

Quick start manual (8 pages)

Table of Contents

Problem

I The batteries are inserted in

I The power

wrong direction.

cannot be

turned on.

I The Pads are not attached to

I The power

the skin.

I Pads are removed from the skin.

turns off

too soon.

I The power

I The batteries are worn out.

I The power turns off automatically

turns off

while using

in 15 minutes.

the unit.

I The Electrode Cord is broken.

I The clear film on the adhesive

surface of the Pad is not peeled off.

I The adhesive surface of Pad is dirty.

I The Pad

does not

attach to the

I You used the Pad immediately

skin.

after washing it.

I The adhesive surface of Pad is

damaged.

I You used the Pad while you were

perspiring.

I The

I You washed the Pad too long

adhesive

and too frequently.

surface of

I You stored the Pad under high

Pad is sticky.

temperature, high humidity, and

direct sunshine.

I The Pad is not attached close to

the skin.

I The Pads are attached

overlapping each other.

I Cannot

I The Electrode Cord is not

feel the

connected correctly.

stimulation.

I The intensity is adjusted too weak.

I The batteries are worn out.

I The adhesive surface of Pad

is damaged.

I The treatment time is too long.

I The skin

I The Pad is not attached close to

turns red.

the skin.

I The skin

I The adhesive surface of Pad is

feels

dirty or dried.

irritating.

I The adhesive surface of Pad is

damaged.

❇ If the unit does not operate after taking the above-mentioned measures, contact the nearest OMRON dealer.

Cause

Remedial Action

⇒ Insert the batteries in correct direction.

⇒ If the Pads are not attached to the skin, the power

will turn off automatically.

⇒ If the Pads come off from the skin, the power

will turn off automatically.

⇒ Replace the batteries with new ones.

⇒ Turn off the Intensity Dial/Power Button.

Unless it is turned off, the batteries will wear out

slightly faster.

⇒ Replace the Electrode Cord.

⇒Peel off the clear film on the adhesive surface.

⇒Wash the adhesive surface softly with your fingertips

under slow running water for several seconds.

⇒Sufficiently dry it and leave the adhesive surface to

airdry.

⇒Pad is a consumable.

Replace the Pad with a new one.

⇒Leave the Pad in the refrigerator overnight.

(Refer to page 20)

⇒Attach the Pad close to the skin.

⇒Attach the Pads by not overlapping them.

⇒Connect the Electrode Cord correctly.

⇒Turn the Intensity Dial/Power Button.

⇒Replace the batteries with new ones.

⇒Pad is a consumable.

Replace the Pad with a new one.

⇒ Limit the treatment time to 10 to 15 minutes.

⇒ Attach the Pad close to the skin.

⇒ Wash the adhesive surface of Pad softly with your

fingertips for several seconds under slow

running water.

⇒ Pad is a consumable.

Replace the Pad with a new one.