Table of Contents
Advertisement
Simrad MF90 Installation Manual
5
Insert the physical dimensions of your vessel (length and width).
Do this as accurately as possible. This information is used to create a new origin in the
vessel coordinate system.
6
Offset:
a
If you want to keep the default reference point (origin), leave all offset values to
0 (zero).
b
If you want to move the reference point to another location, use the necessary
offset values.
To find these offset values, consult the vessel drawings. Do this as accurately as
possible.
7
At the bottom of the page, select
8
Continue your work in the
Result
A common reference point for the sensors and transducer has now been established.
Further requirements
You must proceed by defining the locations of the navigation system antenna, the motion
reference sensor, and the transducer. These locations are all referenced to the same reference
point.
Related topics
Setting to work, page 186
Inserting the installation parameters, page 259
262
to save your settings.
Apply
dialog box, or select
Installation
to close it.
OK
476671/B
Advertisement
Table of Contents
