Table of Contents
Advertisement
Available languages
Available languages
FEATURES
•
Suitable for 1-way of multi-way full dimming and switching.
•
Minimum load down to 3W of capacitive or restistive load, such as dimmable LED Lighting, Incandescent
Lighting, MV Halogen/LV Halogen Lighting with electronic transformers.
•
Lamps soft start operation, to extend longer lifetime for the lamp.
•
LED back light for indication of the dimming mode.
•
User setting for the minimum dim level.
•
Build in short circuit protect, designed to ensure the dimmer can survive in case of wiring fault or catastrophic
failure of the load.
•
Build in resettable thermal cut-off to protect the dimmer over normal operation temperature caused by overloads.
NORMAL OPERATION
Operation of dimmer knob and push switch:
Push knob ON or push knob OFF or hold the knob to dim.
Turn the knob clockwise to increase brightness.
Turn the knob anti-clockwise to reduce brightness.
NOTE:
When connect with iron core transformers, only leading edge mode (LE) could be applied, the TE mode can not be
used in this case. Multiple compatible loads can be used as the total lamp wattage does not exceed the maximum
load rating of the dimmer. Some lamps may exhibit unexpected performance characteristics when cold. Dimming
performance should improve after the lamp warms up. Or in case of lamp appears unstable status, it could be changed
to TE or LE mode.
EN
Advertisement
Table of Contents
