Electrical Specifications - Hoftronic 5435911 User Manual

ELECTRICAL SPECIFICATIONS

PARAMETER
Supply voltage & Frequency
Dimming technology
Rating
Compatible loads
Operating Temperature
Operating Humidity
Mounting Centres
NOTE:
Operation at elevated temperatures or voltages may cause the thermal protection
circuit to operate. If this happen, decrease the connected load to prevent re-occurance.
MINIMAL BRIGHT LEVEL SETTING
Each step must be performed within 15 seconds, if not, it will time out and go to the auto exit program without saving.
VALUE
220-240V ~ 50Hz
Auto Detect Trailing/Leading edge driven control. Minimal bright
level setting can be set by user manually.
10-100W: incandescent lamps, high voltage
halogen lamps and electronic step-down converter
for extra low-voltage incandescent lamps.
3-250W: dimmable LED lamps.
Dimmable LED lighting
with compatible Electronic
Transformers
Incandescent lighting,
MV Halogen lamps
LV Halogen Lighting
with electronic transformers
LV Halogen Lighting
with iron core transformers
0°C - 35°C
10 - 90% R.H.
82mm EU Pattern Plate
HOW TO SET THE MINIMUM BRIGHT LEVEL:
Adjust the required minimum brightness then short
press 5x within 5 seconds to save a minimum level,
your LED lighting will flash 3 times.
HOW TO RESET THE MINIMUM BRIGHT LEVEL:
Short press 7x within 5 seconds to reset the
minimum level, your LED lighting will flash 3 times.
Adjust to required minimum brightness and short
press 5x within 5 seconds to save minimum level,
your LED lighting will flash 3 times.
EN