Advertisement
WIRELESS REPEATER FOR TB7200/7600 SERIES WIRELESS THERMOSTATS
INSTALLER CONFIGURATION PARAMETER MENU
Local configuration:
1. Remove the repeater cover.
2. To enter configuration mode, press and hold the left button for 8 seconds.
3. Press the left button repeatedly to scroll between all the available parameters.
4. Use the (up/right) and (down/middle/center) key to change the parameter to the desired value.
5. To acknowledge and save the new value, press the Left button again.
6. The next listed parameter is now displayed.
Left
• Enters the configuration mode. Press and hold for 8 seconds
• Pressing repetitively will scroll all available parameters one by one
Middle/Center
Adjust/rotate parameter value down
Right
Adjust/rotate parameter value up
Configuration
parameters
Repeater networking address
Com Addr
Default value = 254
Range is: 0 to 254
PAN ID
Personal Area Network
Identification
Default value = 0
Range is: 0 to 500
Channel selection
Channel
Default value = 10
Set to: 15 or 25
Range is: 10 to 26
62-2022—05
Table 3. Configuration Buttons Interface
Table 4. Configuration Parameters
Default value
Significance and adjustments
Valid range is 0 to 254. Each device on the network must have a
unique com address.
This parameter is used to link specific thermostats or repeaters to a
single specific Honeywell WEBs controller with a wireless
communication card. For every thermostat or repeater reporting to a
wireless communication card be sure you set the SAME PAN ID
value both at the gateway and the wireless device(s).
The default value of 0 is NOT a valid PAN ID. The valid range of
available PAN ID is from 1 to 500
This parameter is used to link specific thermostats or repeaters to
specific Honeywell wireless communication card. For every
thermostat or repeater reporting to a Honeywell WEBs controller with
a wireless communication card be sure you set the SAME channel
value both at the gateway and the wireless device(s).
Honeywell recommends using only the following channels:
15 or 25.
The default value of 10 is NOT a valid channel. Although the valid
range of available channels is from 11 to 26 use only channel 15 or
25 to avoid interference with other wireless devices.
6
Advertisement
