Advertisement
REPEATER STATUS LED
IMPORTANT
Be sure all thermostats/repeaters connected to a WEBs-AX controller have the same PAN ID and Channel as
the WEBs-AX wireless communication card (TB-VWG-APP-1014).
1 x 200ms short blink
2 x 200ms short blinks
3 x 200ms short blinks
4 x 200ms short blinks
4 x 200ms short blinks and
1 x 1500ms long blink
1. If a repeater is not detected by the WEBs-AX controller, verify that the LED is blinking at least 4 times. If it is only
blinking twice, ensure that the PAN ID and Channel of the thermostat and repeater are the same as the
WEBs-AX controller it must communicate with.
2. When commissioning a network, use channels 15 or 25. Alternate these channels between floors.
3. If a particular repeater or thermostat refuses to join the network and cannot be seen by the WEBs-AX controller,
move the device closer to the WEBs-AX controller until it has joined the network and it is added to the database.
It can then be re-located to its original position.
STATUS DISPLAY INSTRUCTIONS
The repeater features a two-line, eight-character display.
When left unattended after configuration, the repeater will display its currently assigned
communication address.
M16986
WIRELESS REPEATER FOR TB7200/7600 SERIES WIRELESS THERMOSTATS
Table 1. Repeater Wireless Adapter LED Status Indicators
Power on
Power on and adapter communicating with repeater base
Power on, adapter communicating with repeater base and there is connectivity to wireless
network
Power on, adapter communicating with repeater base, connectivity to wireless network
and WEBs-AX controller is communicating with wireless repeater
Power on, adapter communicating with repeater base, connectivity to wireless network
and WEBs-AX controller is communicating with wireless repeater
Table 2. System Troubleshooting Recommendations
5
62-2022—05
Advertisement
