Makita DTS141 Technical Information page 11

W
iring diagram
Fig. D-2
Be careful not to give damage
to Printed wiring board and
its lead wires when assembling
them in the place here.
Put Connector of
LED circuit here.
Stator's Lead wires (3pcs.)
have to be put on the other
lead wires in this area.
Do not put any lead wires
on these Ribs.
At least Black lead wire of
Terminal has to be put with
this lead wire holder.
Lead wires of Terminal
must be put on the tab of
Controller.
Printed wiring
board
Stator
Unit case
complete
Switch
Controller
Terminal
Tab of Controller
Controller
Pass Lead wires of LED circuit between Rib A and
Boss A, between Rib A and Unit case complete,
and between Rib B and F/R change lever.
Rib B
LED circuit
Rib A
F/R Change lever
Put Closed end connectors in this space
while keeping enough distance from
Capacitor of Controller.
Three Controller's lead wires they are
connected to Closed end connectors
must be fixed with this lead wire holders.
Capacitor of Controller
Controller
P 11/ 11
Boss A