Transportation, Storage And Disposal - Husqvarna K 770 VAC Operator's Manual

Problem
The blade guard extender and the
dust shield do not move freely.
The blade guard extender and the
dust shield do not move back when
the product is removed from the work
piece.
Transportation and storage
• Safely attach the product during transportation to
prevent damage and accidents.
• Remove the cutting blade before transportation or
storage of the product.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the cutting blades in dry, frost free conditions.
• Examine all new and used blades for transport and
storage damage before assembly.
• Clean and maintain the product before storage.
Maintenance schedule on page 54 .
Refer to
• Remove the fuel from the fuel tank before long-term
storage.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
705 - 003 - 22.04.2022
Cause
The moving parts of the blade guard
extender and the dust shield are
clogged.
The springs of the blade guard ex-
tender and the dust extractor do not
operate correctly.

Transportation, storage and disposal

Possible solutions
Clean the moving parts.
Do a check of the springs. Clean the
springs.
• When the product is no longer in use, send it to
a HUSQVARNA dealer or discard it at a recycling
location.
61