Transportation, Storage And Disposal - Husqvarna K1 PACE Operator's Manual

Symbol on the control pan-
el
Transportation and storage
• Secure the product during transportation to prevent
damage and accidents.
• Remove the cutting blade before transportation or
storage of the product.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the cutting blades in dry, frost free conditions.
• Disconnect the battery from the product.
1598 - 002 - 14.02.2022
Problem
The product stops when
you apply work load.
The product operates but
there is no indication light
on the control panel.
The warning indicator
flashes red. Temporary
warning.
The red warning indicator
is on
The yellow temperature
warning indicator is on.
The X-Halt indicator flash-
es.
The X-Halt indicator is on.
1 green LED flashes.
All green LEDs flash.
LED 3 flashes and LED 4 is
on permanently.

Transportation, storage and disposal

Cause
You have put too high load
on the product.
Servicing is necessary.
Temperature deviation, if
the temperature warning in-
dicator is also on.
Defective battery.
Incorrect direction of rota-
tion.
The power trigger is push-
ed during startup.
The power trigger and the
On/Off button are pushed
at the same time.
Servicing is necessary.
Temperature deviation.
The X-Halt function is en-
gaged.
Servicing is necessary.
Low battery voltage.
Servicing is necessary.
Servicing is necessary.
• Examine all new and used blades for transport and
storage damage before assembly.
Disposal of the battery, battery charger
and product
The symbol below means that the product is not
domestic waste. Recycle it at a recycling station
Solution
Start the product and use
less load.
Speak to an approved
Husqvarna service center.
Let the product cool down if
it is too hot. If it is too cool,
put it indoors to warm up.
Replace the battery.
The product stops. Pull the
power trigger to reset.
Release the power trigger
during startup.
Release the power trigger.
Speak to an approved
Husqvarna service center.
The product is too hot or
too cold.
Wait for the cool down peri-
od to complete.
Speak to an approved
Husqvarna service center.
Charge the battery.
Speak to an approved
Husqvarna service center.
Speak to an approved
Husqvarna service center.
31