Page 1
INSTRUCTION MANUAL IM234R03 Moisture Sensor Relay • Connections to Aquavar SOLO and SOLO • Connections to S-Drive and SPD • Connections to Aquavar AB2 (AquaBoost II) • Connections to e-SM Smart Motor • Connections to Aquavar IPC • Connections to Hydrovar INSTALLATION AND OPERATION MANUAL FOR 9K583, 9K584, AND 9K585...
SAFETY INSTRUCTIONS Disconnect and lockout electrical power WARNING before installing or servicing any TO AVOID SERIOUS OR FATAL PERSONAL INJURY electrical equipment. OR MAJOR PROPERTY DAMAGE, READ AND FOLLOW ALL SAFETY INSTRUCTIONS IN MANUAL ELECTROCUTION HAZARD. WARNING AND ON EQUIPMENT. CONTROLLER INPUT GROUND THIS MANUAL IS INTENDED TO ASSIST IN THE TERMINAL (GND) AND ALL EXPOSED METAL...
Page 3
AQUAVAR SOLO, SOLO AND BALANCED FLOW Connections for Moisture Sensor (Part Number 9K585) for Balanced Flow, Aquavar SOLO, SOLO 3AB2, 5AB2; AB2 Controllers Connect White and Connect Red wire Green wires from from Moisture Moisture Sensor to Sensor to transducer the RUN/STOP INPUT terminal marked "R"...
Page 4
S-DRIVE AND AQUAVAR SPD Connect Black wire from Moisture Sensor to the terminal Connect Red wire from number 9 on Moisture Sensor to the terminal controller. number 8 on controller. Connect White and Green wires from Moisture Sensor to the terminals 1 and 2 on controller.
Page 5
e-SM WITH MOISTURE SENSOR Connections for Moisture Sensor (Part Number 9K584) for eSM Smart Motors Connect red wire from Moisture Connect white wire Sensor to terminal 6 (15VDC) on from Moisture Sensor to terminal 12 (Stop) on eSM Connect green wire Connect black wire from Moisture Sensor from Moisture Sensor...
Page 6
IPC WITH MOISTURE SENSOR Connections for Moisture Sensor (Part Number 9K583) to IPC and Hydrovar Connect red and green wires from Moisture Sensor to terminal 13 (24 V OUT) on IPC Connect black wire Connect white wire from Moisture Sensor from Moisture Sensor to terminal 20 (COM) to terminal 18 (D IN)
Page 7
HYDROVAR WITH MOISTURE SENSOR Connect red wire Connect black wire from Moisture from Moisture Sensor Sensor to terminal 4 to terminal 6 (GND) (24V) on Hydrovar on Hydrovar Connect green wire Connect white wire from Moisture Sensor from Moisture Sensor to terminal 18 (ON/ to terminal 19 (GND) OFF) on Hydrovar...