Subscribe to Our Youtube Channel
Related Manuals for Sheldon 2015
Summary of Contents for Sheldon 2015
- Page 1 LOW TEMPERATURE ILLUMINATED INCUBATOR : 2015 ODEL NSTALLATION AND PERATION ANUAL...
- Page 2 RECEIVING AND INSPECTION overloading. 2.4 Cleaning: The incubator's interior was Your satisfaction and safety require a cleaned at the factory, but it should be recleaned complete understanding of this unit. Read the now. Remove all interior parts, including shelves instructions thoroughly and be sure operators and shelf clips.
- Page 3 5.0 CONTROL PANEL OVERVIEW: 5.4 Temperature Program Timer: This is a continuous timer with a 24 hour dial. To set day or Figure 1 night temperature, the program timer must be in either day for day (or high) temperature, or night for night (or low) temperature.
- Page 4 6.6 There is an electrical outlet inside the temperature set point. chamber for use with equipment not exceeding 1 amp. 6.5 Timer Instructions: Your model 2015 has two separate timer controls. One is labeled Temperature Program Timer and the other is 7.0 MAINTENANCE: labeled Light Program Timer.
- Page 5 8.0 PARTS LIST APPENDIX 1 CALIBRATION PROCEDURES Part # Description Plug incubator into electrical service corresponding to data label rating. 101758 Circuit Breaker 100001 High Limit Control Place reference thermometer in the center of 103364 MP Control Ass'y the chamber and allow to stabilize for 24 hours. (The thermometer should not be touching any 891024 Control Relay...
Need help?
Do you have a question about the 2015 and is the answer not in the manual?
Questions and answers