Advertisement
Electric Recline
Wave
PC-086Troubleshooting Guide
Step 3: If the chair is still not receiving power, replace the
main PCB box and the power cord.
The chair will only move in one direction.
If the chair will either recline or incline, but not both, it is possible that
the electric recline cable connection to the armrest is not secure. To
check it:
1. Use both hands to pop off the inside left-hand side panel, exposing
the cable connection.
2. Make sure the connection is secure.
3. If the problem still exists, replace the left-hand armrest.
4. If replacing the left-hand armrest (containing the electric recline
lever) does not resolve the problem, replace the backrest actuator.
The chair will not recline or incline.
1. Verify that the chair is plugged into a working wall outlet.
2. Verify that there is weight distributed across the chair (not just on
the back of the seat) when attempting to recline the chair. Your
weight must be distributed across the backrest, seat and footrest.
3. Verify that there is nothing pressing against the footrest when
attempting to recline the chair, as this will prevent the chair from
reclining.
4. Replace the backrest actuator.
5. If replacing the backrest actuator does not resolve the problem,
replace the left-hand armrest (containing the electric recline lever).
The wave function is noisy.
NOTE
A slight humming noise is normal when the wave function is in
use.
Replace the air compressor assembly.
3
Advertisement
