Mackie 808S Technical Specifications page 3

PPM 808S
Output Impedance
Main Mixer Output:
Insert Output:
Tape Output:
Monitor Output:
Effects Send:
Power Amp Out:
Digital Effects
Resolution:
Sample Rate:
Bandwidth:
VU Meters
Main and Monitor
8 segments: Clip, +5, 0, –5, –10, –15, –20, –30
Power Amplifier Section
Maximum Power at 1% THD, midband,
both channels driven
600 watts per channel into 2 Ω
450 watts per channel into 4 Ω
300 watts per channel into 8 Ω
Continuous Sine Wave Average Output Power, both
channels driven (rated power)
340 watts per channel into 4 Ω from 40 Hz to 20 kHz, with no
more than 0.15% THD
240 watts per channel into 8 Ω from 40 Hz to 20 kHz, with no
more than 0.10% THD
Power Bandwidth
< 10 Hz to 30 kHz (+0, –1 dB) @ rated power into 4 Ω
Frequency Response
< 10 Hz to 30 kHz (+0, –1 dB)
< 10 Hz to 55 kHz (+0, –3 dB)
Distortion
THD, SMPTE IMD:
Signal-to-Noise Ratio
> 105 dB below rated power into 8 Ω
Channel Separation
> 75 dB @ 1 kHz
3
O F 6 P A G E S
Powered Mixer
150 Ω
150 Ω
150 Ω
150 Ω
150 Ω
0.032 Ω @ 1 kHz
16-bit, 2-channel
31.25 kHz
15.6 kHz
< 0.10% @ 8 Ω
< 0.15% @ 4 Ω
Damping Factor
> 250 @ 1 kHz
Amp Input Impedance
10 kΩ unbalanced, 20 kΩ balanced
Input Sensitivity
1.76 volts (+7.1 dBu) for rated power into 4 ohms
Gain (Amp In to Speaker Out)
26.4 dB (21 V/V)
Maximum Input Level
9.75 volts (+22 dBu)
Rise Time
< 6.2 µs
Slew Rate
> 50 V/µs
High Frequency Overload and Latching:
No latch up at any frequency or level.
High Frequency Stability:
Unconditionally stable, driving any reactive or
capacitive load
Turn On Delay:
3 seconds
AC Power Requirements
United States:
Europe:
Japan:
Korea:
(Capable of operation from 75% to 110% of rated line
voltage)
Physical
Height:
Width:
Overall Depth:
Weight:
20.5" (521 mm)
120 Vac, 60 Hz
240 Vac, 50 Hz
100 Vac, 50/60 Hz
220 Vac, 60 Hz
11.7 inches (297 mm)
20.5 inches (521 mm)
13.0 inches (330 mm)
36 pounds (16.3 kg)
13.0" (330 mm)