Advertisement
CHANGING THE HYDRAULIC FLUID
4.2
Follow the steps below to change the hydraulic fluid.
STEP 1. Ensure pump is unplugged from power source and system
pressure has been released.
STEP 2. Loosen and remove reservoir drain plug using a 6mm hex
wrench. See FIG E.
STEP 3. Drain oil into approved container and dispose of properly
according to local regulations.
STEP 4. Unscrew and remove the bolts holding the reservoir to the top
plate of the hydraulic pump.
STEP 5. Lift the top plate off of the pump reservoir, being careful not
to damage the pump body and set aside.
STEP 6. Clean the pump reservoir and reservoir magnet with a mild cleaning agent and wipe dry. Ensure that
any small pieces of paper towel or rag are removed from the reservoir.
STEP 7. Unscrew the oil filter by hand from the pump body and clean using a mild cleaning agent and a soft
brush. Flush the filter with clean hydraulic fluid to ensure any cleaning agents and/or
small particles have been removed from the filter. If the oil filter is damaged contact the nearest
authorized Eagle Pro service center to order a replacement.
STEP 8. Screw oil filter back onto pump body, be sure to only hand tighten oil filter. Over tightening may
damage the pump body.
STEP 9. Reassemble pump and reservoir.
STEP 10. Once pump is completely assembled, add new, clean ISO #32 hydraulic fluid, see Section 02
Initial Setup Instruction's on how to add hydraulic fluid.
EAGLE PRO INDUSTRIAL TOOLS, INC.
FIG E
9
Reservoir Oil Drain Plug
FORM NO. E09005 REV. A.
Advertisement
