Advertisement
01
SAFETY INSTRUCTIONS
Carefully inspect all components for shipping damage. If shipping damage is found, notify the carrier at once.
The carrier is responsible for any damage resulting from shipment.
To avoid personal injury or property damage, please read, understand, and follow all safety instructions.
EAGLE PRO is not responsible for injury or damage resulting from unsafe and/or incorrect product use or
system operation, or lack of proper maintenance.
DANGER!
Is used only when your action or lack of action may cause serious injury or death.
WARNING!
Is used when a potential danger exists that requires correct action to avoid personal injury.
IMPORTANT!
Is used when action of lack of action can cause equipment failure.
IMPORTANT!
To avoid personal injury or property damage, please read, understand, and follow all safety instructions.
Always keep work area clean and free of clutter.
When not in use, tools should be properly stored to avoid damage .
Operator must wear proper safety attire when working with hydraulic equipment. Work gloves, safety
glasses, hard hats, approved safety shoes, and hearing protection and/or other required clothing should be
worn while operating this equipment.
DANGER!
The hydraulic equipment user must be a qualified operator with correct training and work experience with
hydraulic equipment. Lack of knowledge in any of these areas can lead to equipment damage or personal
injury.
Carefully inspect hydraulic pump before using . If any damage is found, discontinue use and contact your
closest authorized EAGLE PRO Service Center.
To avoid personal injury, do not modify or weld hydraulic equipment without approval of EAGLE PRO
INDUSTRIAL TOOLS, INC.
EPB electric pumps are designed for a maximum of 10,000 PSI/700 bar. Ensure that all hydraulic
equipment (cylinders, hoses, accessories, etc.) used with these pumps are rated at 10,000 PSI/700 bar
pressure rating or equipment damage may occur.
Always stay clear of loads supported only by hydraulic means. A cylinder is a load lifting device, not a
load holding device. After a load has been raised or lowered it must always be supported mechanically.
EAGLE PRO INDUSTRIAL TOOLS, INC.
2
FORM NO. E09005 REV. A.
Advertisement
