Table of Contents
Advertisement
•
Measurement of Cylinder bore
Assemble the cylinder liner at the
cylinder block and measure inner
diameter at upper, middle, lower that
is, 3 steps by 45
calculate the average values after
eliminating
minimum values.
Standard
127.990 ~
•
Measure the clearance between the
cylinder liner bore and the piston outer
diameter, if it is more than the use limit
value, replace either one that is more
severe.
Standard
3) Piston ring and ring groove
Inspection
In case of piston ring's wear, damage or
engine overhaul, replace piston rings.
Gap clearance
Measure the piston ring cut part.
•
Insert the piston ring at the cylinder
liner's upper part perpendicularly.
•
With a feeler gauge, measure the gap
clearance of piston ring.
•
If the measured value exceeds the
limit value, replace it.
•
Piston ring gap
Division
Standard
Top ring
0.35 ~ 0.55 mm 1.5 mm
2nd ring
0.40 ~ 0.60 mm 1.5 mm
Oil ring
0.40 ~ 0.70 mm 1.5 mm
O
interval and
the
maximum
and
128.010 mm
0.233 ~ 0.271 mm
Limit
- 89 -
2
EAMD067I
Advertisement
Table of Contents
