Mackie 1202-VLZ Pro Reference Manual page 9

This changes AUX SENDS 1 and 2 , with the
pre switch engaged, to receive their signals post-
EQ instead of pre- EQ . The signal remains post-
low cut, pre-mute and pre-fader. With the pre
switch disengaged (up), the signals are not
affected by the mod. The following must be per-
formed for each channel you wish to modify:
1. Remove all cords, including the power
cable, from the 1604-VLZ PRO.
2. Place the mixer upside-down on a dry,
non-marring surface.
3. If you have converted your mixer to the
rack-mount position or have installed a
RotoPod, undo those changes and tempo-
rarily configure the mixer in the original
desktop mode. You do not have to install
the pod, just get it out of the way of the
bottom cover.
CUT
HERE
5
JUMPERS
HERE
6
4. Remove the screws that attach the bot-
tom cover. Keep track of what screws go
where. Remove the bottom cover.
5. Cut the conductor at point C, between
the square and round pads. Be careful to
cut all the way through the conductor,
and do no cut any nearby traces. Each
channel is slightly different, but this
graphic shows Channel 16, which is very
different from the others, and Channel
15 (respectively), which is similiar to the
remaining channels.
6. Add a jumper from the square pad at
point B to the square pad at point C.
7. Repeat for each channel you wish to
modify.
8. Check your work very carefully, them put
the bottom cover back the way you found
it. You're done!
9