Mackie 1202-VLZ Pro Reference Manual page 14

B. When the Aux 1/2 Pre Switch is not
engaged, Aux Send 1 and 2 function nor-
mally, as post fader channel sends.
All that said, here's the mod.
See Figure above. This modification takes
place on each channel strip in the area
under the AUX 3/4 Mix-V Source switch
and also under and near the AUX 1/2
PRE switch.
1. Remove power cord.
2. Cut two (2) traces at point (A).
Note: The wire used in the next three
steps should be 24-28 gauge insulated
jumper wire.
Do not strip off any more insulation than
is absolutely necessary.
3. Add a 1-1/2" jumper (B), connected at
points K and L.
4. Add a 2-1/4" jumper (D), connected at
points P and Q.
14