Mackie 1202-VLZ Pro Reference Manual page 11

This modification changes the tap point of all
"pre" AUX sends from post -EQ to pre -EQ. It
must be done on each channel. For example,
if you have a 24•8, the modification must be
done on all 24 input channels.
See Figure below. This modification takes
place on each channel strip in an area under
the AUX 1/2 Pre/Post switch.
1. Remove power cable.
2. Cut the conductor at Point A.
BEFORE
cut here (A)
AFTER
add jumper (B)
3. Add a jumper at Point B.
4. Repeat for all input channels.
This modification changes the tap point of
the SOLO bus from post-fader/post-mute (ste-
reo) to pre-fader/pre-mute (mono). It must be
done on each channel. For example, if you
have a 24•8, the modification must be done
on all 24 input channels.
See Figure below. This modification takes
place on each channel strip in an area under
the channel fader.
1. Remove power cable.
2. Cut the conductor at Point C.
3. Cut the conductor at Point D.
4. Add a jumper at Point E.
5. Add another jumper at Point F.
6. Repeat for all input channels.
BEFORE
AFTER
11
cut here (C&D)
add jumpers
(E&F)