Advertisement
SAMPLE HUB AND CONNECTOR INSTALLTION
Carflex Fittings Installation Instructions
LT43C-CAR, LT43F thru J, LT20C-CAR, LT20F thru J.
1. Cut the end of the Carflex conduit or Carflex
2. Install compression nut and sealing gland ring over the end of the conduit or tubing.
3. Insert the ferrule end of the fitting into the conduit using a clockwise twisting action.
4. Screw fitting body into compression nut.
5. When installation is completed, use a wrench, tighten compression nut one-quarter
(1/4) turn past hand-tight. Do not over tighten fitting.
*To prevent damage to conductors, conduit and fittings, do not twist Carflex during
installation.
LT43D-New, LT43E-New, LT20D-New, LT20E-New.
1. Cut the end of the Carflex conduit or Carflex
2. Install compression nut over the end of the conduit or tubing.
3. Insert the ferrule end of the fitting into the conduit using a clockwise twisting action.
(Be sure conduit is fully inserted to the bottom of the fitting shoulder).
4. Screw compression nut onto fitting body.
5. Use a wrench, and tighten compression nut one (1) full turn past hand-tight. Do not
over tighten fitting.
*To prevent damage to conductors, conduit and
fittings, do not twist Carflex during installation.
Jet Inc. 750 Alpha Drive Cleveland, OH 44143 www.jetincorp.com 800.321.6960
INSTRUCTIONS
X-Flex
®
™
X-Flex
®
™
tubing square.
tubing square.
QA-SAL-132
- - 6 - -
REV 7/31/2013
Advertisement
