Cobra microTALK PR3000DXC Owner's Manual page 10

Mode Functions
Operation
Intro Operation Customer
Channel Scan
Intro Operation
Assistance
Your microTALK ® radio can automatically scan channels.
To scan channels:
Mode Button
1. Press the Mode button until the Scan icon
and the channel numbers flash on the display.
Secondary Icons
Secondary Icons 2. Press the Channel Up or Channel Down
button to begin scanning channels.
Scanning Channels
The Scan icon will continue to be displayed when
Notice
Channel Button
Notice
scan is on. Your radio will continue to scan all
channels and stop if an incoming transmission is
detected. Your radio will remain on that channel
for 10 seconds.
While setting channel scan, if you do not
press any buttons for 15 seconds, your radio
will automatically return to Standby mode on
the channel or channel/privacy code displayed
before you entered mode functions.
10 English
Warranty
Customer Warranty
Assistance
The radio ignores specific privacy
codes while scanning channels.
Introduction
During channel scan (while receiving an incoming transmission),
•
you can choose from the following:
a. Press and hold the Talk button to communicate on that
channel. Your radio will remain on that channel and return
to Standby mode.
b. Press the Channel Up or Channel Down button to resume
Secondary Icons
scanning channels.
If you press the Talk button while scanning and not within
10 seconds of receiving a transmission, you will transmit
on the channel on which you last received a transmission.
This will return the radio to Standby mode.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning channels.
During channel scan (while not receiving a transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on the
channel or channel/privacy code that was displayed before
you entered mode functions or the channel on which, during
scanning, you last received a transmission. This will return
the radio to Standby mode.
b. Press the Mode button to proceed to set privacy code scan
on the channel that was either displayed before you entered
mode functions or on which, during channel scanning, you
last received a transmission (see below for further details).
c. Press the Lock button to return to Standby mode on the
channel/privacy code that was displayed before you entered
mode functions or the channel on which, during scanning,
you last received a transmission.
Operation
Customer Assistance Warranty
Intro Operation Customer
Assistance
Notice
Nothing comes close to a Cobra
Warranty
™ 11