Table of Contents
Advertisement
Fault
All LEDs lit up or
flashing.
Fault
Appliance door can-
not be closed.
Lid on the detergent
dispenser cannot be
closed.
Fault
Filling valves making
knocking noises.
Knocking or rattling
noise.
Cause and troubleshooting
Electronics have detected a fault.
Press the main switch button for approx.
1.
4 seconds.
→ "Controls", Page 16
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
‒
the fuse box.
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
‒
mains plug.
Switch the appliance on.
‒
If the problem occurs again:
3.
Contact customer service.
‒
→ "Customer Service", Page 57
Cause and troubleshooting
Door lock has been activated.
Close the appliance door with greater force.
▶
Door cannot be closed due to installation method.
Check whether the appliance has been installed
▶
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Detergent dispenser or lid are blocked by sticky deter-
gent residue.
Remove detergent residue.
▶
Cause and troubleshooting
Caused by the domestic installation. No appliance
fault present. Does not affect functioning of the appli-
ance.
Can only be remedied in the domestic installation.
▶
Spray arm is striking tableware.
Arrange tableware so that the spray arms do not
▶
strike tableware.
With a small load the water jets directly strike against
the tub.
Distribute the tableware evenly.
▶
Troubleshooting aus
53
Advertisement
Table of Contents
