Pedestal Trim Installation; Bricks And Baffle Installation - Napoleon TIMBERWOLF PEDESTAL T2250 Installation And Operating Instructions Manual

56
5.3

PEDESTAL TRIM INSTALLATION

Ensure that the pedestal surfaces are clean and dry; peel the protective backing from the trim adhesive. Insert
one end of the brass trim into one of the slots located in the pedestal and pressing fi rmly, proceed around
to the other slot. Cut trim to size. Attach the rear knockout plate (located inside the ash pan for shipping
purposes).
EN
5.4

BRICKS AND BAFFLE INSTALLATION

OPERATIION OF THE APPLIANCE WITHOUT THE BAFFLES CAN RESULT IN EXCESSIVE
With appliance and chimney installation completed, move the bricks into place for your appliance as
illustrated.
A. Install the bottom bricks, working from the back of the appliance forward.
B. Before installing the back bricks, loosen the screw holding the brick retainer and insure that it has
been moved forward. Install the six bricks along the back wall by pivoting the bricks up under the brick
retainer. Re-tighten the screw.
C. Install the fi rst two rows of side bricks as shown. Pivot the fi bre baffl e into place with the brick retainter
down and toward the outside of the unit. Slide the top row of bricks into place to support the baffl e. The
baffl e must sit fl at on the outside row of bricks as well as the fl ange on the manifold shield. Push the
baffl e all the way to the rear of the fi rebox, leaving a minimum of 1" (25.4 mm) gap along the front. This
will allow fl ue gases to escape the fi rebox.
D. Install the 4 bricks along the front opening.
NOTE: Do not operate if baffl e and manifold shield are not in position.
W415-1212 / 05.13.13
TEMPERATURES THAT COULD DAMAGE THE APPLIANCE, CHIMNEY AND THE
WARNING
!
SURROUNDING ENCLOSURE.
KNOCKOUT
PLATE
TRIM
PEDESTAL