Omni Tx-5.10 DCC Quick Start Manual

OMNI Tx-5.10
The programmable OMNI Tx-5.10 handheld transmitter will control your garden railway
electric locomotives perfectly from the palm of your hand. An Omni FRx-24 receiver with
be needed to work with the OMNI Tx-5.10 transmitter in DCC mode, but the Tx5.10 will
also operate our standard r/c Rx22 receivers in analogue DC models.
2.4GHz gives glitch free control for up to 800 metres range with no
obstructions.
The Regulator Knob controls speed and direction. Forwards to the right, reverse to the
left. Cruise control is possible by turning off the transmitter while the train is running.
Turn back on to instantly regain control.
FUNCTION 1.2.3 / 4.5.6
Buttons 13.14.15/16.17.18
Buttons 1.2.and 3 in conjunction with
These buttons are also used to re-program a receiver.
Functions 4,5,and 6 are operated by holding the
by holding the red shift button first and functions
buttons whilst pressing the function button required., likewise for functions 13 - 24.
Selector
Switch to change be-
tween functions 1-12
and 13-24
LED's 1 & 2
Indication of battery
and radio status plus
indications during bind
and calibration.
ON/OFF
Slide Switch
Slide down for ON
10 way Selector
Knob
Use it in combination
with Channel switch to
move between models,
then press RED button
to acknowledge, once
you have checked
speed setting.
If Alkaline batteries are used up to 100 hours of continuous
use is possible
DCC
2.4GHz Handheld Transmitter
/ 7.8.9 / 10.11.12
/19.20.21/22.23.24
RED and GREEN Operate DCC command functions
green shift button first, buttons
10,11 and 12 by holding down
Shift Buttons
Green
Enable F4 to F12 in com-
bination with black but-
tons. E.g.
by pressing and holding
the RED
pressing BLACK button
F1. Hold both down to
obtain F10, F11 and F12.
Regulator Knob
Turn right for forwards
and left for reverse. The
further you turn, the fast-
er the loco goes.
Centre Stop.
Whilst moving, if a quick
stop is needed, move the
knob fully to the opposite
direction for an E-stop
This stops ALL active
models.
This knob is also used
2 x AAA Battery box
when reprogramming the
top buttons.
OMNI
Programmable 2.4GHz Transmitter
For simultaneous control of up to
10 models and 24 functions on
WWW.FOSWORKS.CO.UK
Tel 01254 814675
7,8 and 9
Regulator Knob Forwards and backwards with centre stop.
both shift
Toggle switch allows
lector knob allows simultaneous control of up to 10 models.
and Red
2.4GHz Technology by Timpdon Electronics
F7 is obtained
Requires an OMNI Rx24 receiver with DCC interface module or OMNI
button then
Rx22 or Rx2 with optional MCS switchers for analogue DC operation
Rx-24 receiver circuit diagram showing optional use of ESC. Note that stand-
ard Rx24 do not have the ESC connection, Rx24-ESC must be ordered spe-
cially. There are several versions including Drivelock on F8.
Tx-5.10DCC
each model.
P.O.Box 675,
Blackburn, Lancs.
BB2 9QJ
UK
function range to be selected and the se-
24 functions for DCC
With Emergency stop function
operation