Omni Tx-4.0 DCC Quick Start Manual

OMNI Tx-4.0
You no longer need that big transmitter anymore! The programmable OMNI Tx-4.0
handheld transmitter will control your garden railway electric locomotives perfectly
from the palm of your hand. An Omni Rx-4 or 24 receiver with be needed to work
with the OMNI Tx-4.0 transmitter in DCC mode, but the Tx4.0 will also operate our
standard r/c Rx2 or Rx22 receivers installed in analogue DC models.
2.4GHz gives perfect glitch free control for up to 800 metres range with no
obstructions.
The Regulator Knob controls speed and direction. Forwards to the right, reverse to
the left. Cruise control is possible by turning off the transmitter while the train is run-
ning. Turn back on to instantly regain control. A controlled E-stop is achieved by
moving the knob fully to the opposite direction. A maximum of 2 seconds from full
speed.
FUNCTION Buttons 1.2.3 /
Buttons 1.2.and 3. Operate DCC command functions
On a OMNI Rx4 receiver. These buttons are also used to re-program a receiver.
Functions 4,5,and 6 are operated by holding the
and 9 by holding the red shift button first and functions
down both shift buttons whilst pressing the function button required.
More Info
For more information
see overleaf
LED's 1 & 2
Indication of battery
and radio status plus
indications during
bind and calibration.
ON/OFF
Slide Switch
Slide down for ON
2 x AAA
Battery box lid
If Alkaline batteries are used up to 100 hours of contin-
uous use is possible, do not use rechargeable cells.
DCC
2.4GHz Handheld Transmitter
4.5.6 / 7.8.9 / 10.11.12
green shift button first, buttons
10,11 and
Shift Buttons
Green
Enables F4 to F12 in
combination with green
and red shift buttons.
Regulator
Turn right for forwards
and left for reverse. The
further you turn, the fast-
er the
Centre Stop.
Whilst moving, if a quick
stop is needed, move
the knob fully to the op-
posite direction for a
controlled E-stop (Max 2
secs from full speed)
This knob is also used
when reprogramming the
top buttons.
OMNI Tx-4.0
Programmable 2.4GHz Transmitter
For electric models with DCC
Or analogue DC models with up to 12 functions
WWW.FOSWORKS.CO.UK
Tel 0(44)1254 814675
7,8
Regulator Knob Forwards and backwards Plus
12 by holding
User programmable. With Emergency stop function
and Red
Requires an OMNI Rx4 or Rx24 receiver with DCC interface module or
Rx-24 receiver circuit diagram for use with a DCC Interface module.
Knob
loco goes.
DCC
decoders and ESC
P.O.Box 675
Blackburn, Lancs.
BB2 9QJ
UK
buttons for DCC or DC operation
2.4GHz Technology by Timpdon Electronics
OMNI Rx2 or Rx22 with optional MCS switchers
12 function