AWD Rear Transmission Removal (continued)
AWD Rear Transmission Installation
Drive System: Service and Repairs
g352577
12. Remove the belt guide guard from the deck.
13. Remove the rear height-of-cut plates.
6–12)
14. Remove the transmission from the chassis with the belt and cable attached.
15. Using a R2 square bit, remove the 3 (#10–14) screws securing the belt guide
to the transmission.
g359966
16. Remove the traction cable and spring from the belt guide.
1. Install the traction cable and spring to the belt guide.
2. Install the belt guide to the transmission, secure with 3 (#10–14) screws.
Torque the screws to 2.82 ± 0.56 N • m (25 ± 5 in-lbs).
Figure 140
Rear Height-of-Cut Removal (page
Figure 141
Page 7–14
22 Inch AWD/RWD Steel Deck Walk Power
Mower Service Manual
3445-579 Rev A