Table of Contents
Advertisement
Operator mode
In operator mode, appropriate information is displayed in accordance with
the status of the printer.
The operator basic screen looks as follows, indicating that the printer is ready
for operation and that no job is currently being executed.
When the printer is busy with at least one print job, the print queue screen is
displayed:
The progress indicator keeps the user informed of the progress of a process
(e.g., calculation of a bitmap, printing of a film). The line is gradually filled
from left to right, from 0% to 100% as the process proceeds.
Related Links
Managing the print queue
Key-operator mode
In Key-operator mode, operation is menu driven. The menu displays the
Keyoperator functions.
5 Restore config.
6 Calibration
7 Service Actions
8 Quality Control
9 Installation
The display shows only four lines. In the above figure, they are indicated in
the upper zone. The other possible lines are shown in the lower area and can
be reached by scrolling using the Up/Down arrow keys on the Keypad.
The active keys are indicated by their respective LEDs.
Data entry
When entering numerical or alphanumerical data, always adhere to the
following principles:
Note: On the print queue screen the modality name defined
during installation (nickname) will be used to refer to the
corresponding modality. In case no nickname has been defined
during installation, the AE-title will be used.
on page 72
Visible
Reachable with Up/Down arrow keys
Drystar 5301, Drystar 5302 | Introduction | 65
2831E EN 20161128 1410
Advertisement
Table of Contents
