Table of Contents
Advertisement
Camera Orientation Detection
The camera automatically
detects whether it is
oriented vertically or
horizontally when you
record an image, and
stores the orientation
along with the image data.
Then when you play back images using the bundled Photo
Loader application, they are all automatically oriented
correctly on the display.
Previewing the Last Image Recorded
Use the following procedure to preview the last image re-
corded, without leaving the REC Mode.
1.
Hold down the PREVIEW/
the last image recorded.
• The image remains on the monitor screen as long as
you keep the PREVIEW/
• You can use the PREVIEW/
Mode, too.
• The PREVIEW/
button does not perform any op-
eration if you press it immediately after turning on
camera power or immediately after entering to the
REC mode from the PLAY mode.
RECORDING
button to display
button depressed.
button in the Movie
E-50
Recording Images under Low Battery Power
To protect against unexpected loss of image data, images
are recorded one-by-one whenever the battery level is indi-
cated as
or lower. During the save operation, the mes-
sage "Press DISP to cancel save." is on the monitor
screen. As long as you do not press DISP, the save opera-
tion continues for a few seconds. Be sure to replace all four
batteries as soon as possible after this message starts to
appear.
Pressing DISP while the "Press DISP to cancel save." is
on the monitor screen causes the image save operation to
be cancelled.
IMPORTANT!
The message described above does not appear while
the monitor screen is turned off or while the camera is in
the Movie Mode.
Advertisement
Table of Contents
