Advertisement
The TWISTER has been safety tested and run at our factory prior to shipping. All fluid levels
have been topped off; however, no propane has been added to the tanks for safety shipment
purposes. Before running the TWISTER please check the following items that may have shifted
or changed during shipping.
1.
Raise engine covers and check oil level.
2.
Check air cleaner filter element for snug fit.
3.
All battery cable connections are snug.
4.
Inspect for major hydraulic oil leaks. Snug hydraulic fittings using two wrenches. Use
caution not to over tighten.
5.
Fill propane tank.
6.
Mount propane bottle in brackets, be sure bracket alignment pin corresponds with
alignment slot on bottle.
7.
Attach propane hose to liquid side of bottle by attaching to the handle valve. Snug fit the
female connector attached to hose and slowly turn valve on. You should hear gas briefly
enter the propane hose. Immediately check for propane leaks with soapy water solution.
If leak persists after retightening the knurled female connector: STOP, turn off the bottle
at valve and seek assistance from certified propane professional. Serious damage and or
an explosion could occur.
8.
Check lug bolts for tightness, torque 85-100 lbs.
9.
Return all engine guards to proper position.
10.
You are now ready to start the engine.
11.
Once the engine is warming and running, and the operator is safely in the seat, the
machine can be driven.
Since the TWISTER is a very low maintenance and user friendly machine, the only break-in is
for the HYUNDAI engine. Change break-in oil at 50 hrs as recommended by the engine
manufacturer.
SECTION V
START-UP AND BREAK-IN
NEW MACHINE BREAK-IN
Advertisement
