Advertisement
BLADE CHANGE PROCEDURE
To change
scraping blades:
Clamp Bolts
Stop Engine.
TWF-029
Loosen the smaller
Clamp Bolts at
Blade
the rear of the
blade holder using
a ¾" open-end
wrench. Slide the
dull blade out.
Hold-Down Bolts
Loosen the Hold-
TWF-028
Down Bolts if
necessary to fit the
replacement blade
against the Blade
Blade Step
Step. Retighten
the Hold-Down
Bolts by hand and
then retighten the
Clamp Bolts with your wrench. Lower the blade and resume scraping. With a little practice,
you should be able to change the blades in 15 seconds. Dull blades may be sharpened and reused
many times.
Operators should lower the blade by pressing the left hand lever forward each time they get off
the machine. This safety practice eliminates possible bodily injury from running into the blade
or lowering of the blade by unauthorized operators.
Advertisement
