Operation - Husqvarna 350i Operator's Manual

1. Install the battery charger on the wall with the 2
screws (B). Use wall plugs (A) if it is necessary.
B
B
C
Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the chain brake (A) to make sure that
it operates correctly and that it is not damaged.
2. Do a check of the rear right hand guard (B) to make
sure that it is not damaged.
3. Do a check of the power trigger and the power
trigger lockout (C) to make sure that they operate
correctly and that they are not damaged.
4. Do a check of the keypad (D) to make sure that it
operates correctly.
5. Make sure that there is no oil on the handles (E).
6. Do a check to make sure that all parts are correctly
attached and not damaged or missing.
7. Do a check of the chain catcher (F) to make sure
that it is attached correctly.
8. Do a check of the chain tension (G).
9. Charge the battery (H) and make sure that it is
correctly attached to the product.
16
A
D

Operation

Read and understand the
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger and a
mains socket.
10. Make sure that the saw chain stops when you
release the power trigger.
C D
B H
To use the correct chain oil
WARNING:
which can cause injury to you and the
environment. Waste oil also causes damage
to the oil pump, the guide bar and the saw
chain.
WARNING:
if the lubrication of the cutting equipment is
not sufficient. Risk of serious injury or death
to the operator.
E A
F G
Do not use waste oil,
The saw chain can break
1844 - 003 - 28.07.2022