Assembly - Husqvarna 350i Operator's Manual

and chain drive sprocket. Refer to
page 37 .
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
To assemble the guide bar and saw
chain (with bar knob)
WARNING:
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the bar knob and remove the drive sprocket
cover.
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
1844 - 003 - 28.07.2022
Accessories on

Assembly

Always remove the battery
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
4. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Apply tension to the saw chain. Refer to
Maintenance on page 26 for instructions.
9. Tighten the bar knob.
To install the battery charger on the
wall
CAUTION:
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
Do not use an electric
15