Ulpg Cylinder Installation & Leak Checking - Weber TRAVELER 77202 Owner's Manual

GETTING STARTED
ULPG Cylinder Installation &
Leak Checking
The Traveler includes the accessories required to connect
to a standard refillable ULPG cylinder. To prepare the
barbecue for use with a ULPG cylinder, you will first need
to connect the gas hose and install the cylinder holder.
Connecting and Routing the Gas Hose
1) Attach the male fitting of the gas hose to the
regulator with the CGA600 connection. Tighten by
turning the fitting clockwise (A). Hand tighten only.
While using the gas hose, use care to route the gas hose
away from the cookbox and other hot surfaces (B).
Only use the hose assembly as supplied with this
appliance for connection to the cylinder - DO NOT USE
ADAPTORS.
Installing the Cylinder Holder
1) Place the cylinder holder within the cart, with the top
hooks resting around the upper frame legs (C).
2) Insert the two bottom wire supports into the holes at
the bottom of the frame legs (D).
NOTE: Once installed, the cylinder holder can remain
attached to the cart. It automatically folds flat as the
barbucue is lowered for transportation and storage.
Inspect the Cylinder
Check the ULPG cylinder before use to ensure a proper
gas connection.
• Confirm that the ULPG cylinder valve is fully closed.
Close by turning valve clockwise.
• Confirm that the ULPG cylinder valve is the proper
mating type for the gas hose.
• Inspect the ULPG cylinder valve for damage or debris. If
damaged, return ULPG cylinder to local retailer.
Cylinder Installation
1) Place the ULPG cylinder on the cylinder holder
2) Turn the ULPG cylinder so the opening of the valve
faces the side or back of the barbecue.
3) Secure the cylinder with the cylinder strap (E).
Connect the Gas Hose to the Cylinder
1) Check that the burner control knob is in the
off position. Check by pushing in and turning knob
clockwise.
2) Connect the gas hose coupling to the ULPG cylinder,
Hand tighten only.
a) Tighten by turning the fitting clockwise (F).
IMPORTANT: We recommend that you replace
m
the gas hose assembly on your gas barbecue
every five years. Some countries may have
requirements that the gas hose be replaced
within less than five years, in which case that
country's requirement would take precedence.
For replacement hose, regulator, and valve
assemblies, contact the Customer Service
Representative in your area using the contact
information on our web site.
Log on to weber.com.
12
A
B
C
D
E
F