Lpg Cylinder Installation & Leak Checking; Install The Tank; Installation Location - Weber SPIRIT II E-310 Owner's Manual

LPG Cylinder Installation &
Leak Checking

Installation Location

The LPG cylinder is hung onto the cylinder scale which
is located outside the cabinet base under the right
side table. The LPG cylinder will hang on the cylinder
scale from the collar assembly (the metal protective
ring around the cylinder valve) with the valve opening
facing the back of the barbecue (A).
Inspect the Tank
1) Confirm that the LPG cylinder valve is fully closed.
Close by turning valve clockwise.
2) Confirm that the LPG cylinder valve is the proper
mating type for the regulator (B).
3) Inspect the LPG cylinder valve for damage or
debris. If damaged, return LPG cylinder to local
retailer.

Install The Tank

1) Check that all burner control knobs are in the
off position. Check by pushing in and turning
knobs clockwise.
2) Lift LPG cylinder into position on the cylinder scale.
3) Connect the regulator to the LPG cylinder by
screwing the POL coupling into the LPG cylinder
valve, turning anti-clockwise (C). Hand-tighten
only. Position the regulator so that the vent
hole faces down. Proceed to "CHECKING FOR
GAS LEAKS."
10
A
B
C