Ide Connectors: Ide1/Ide2; Front Panel Connectors: Jfp1/Jfp2; Front Panel Audio Connector: Jaud1 - MSI K8N Neo-V2 Instruction Manual

MSI Reminds You...
1. Always consult the vendors for proper CPU cooling fan.
2. C_FAN1 supports the fan control. You can install the PC Alert utility that will automatically
control the CPU fan speed according to the actual CPU temperature.

IDE Connectors: IDE1/IDE2

The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 66/100/133 controller
that provides PIO mode 0~4, Bus Master, and Ultra DMA 66/100/133 function. You can
connect up to four hard disk drives, CD-ROM, 120MB Floppy and other devices.
The first hard drive should always be connected to IDE1. IDE1 can connect a Master
and a Slave drive. You must configure second hard drive to Slave mode by setting the
jumper accordingly. IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second drive to Slave mode by
setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper
setting instructions.

Front Panel Connectors: JFP1/JFP2

The mainboard provides two front panel connectors for
electrical connection to the front panel switches and LEDs.
JFP1 is compliant with Intel Front Panel I/O Connectivity Design
Guide.

Front Panel Audio Connector: JAUD1

The front panel audio connector allows you to
connect to the front panel audio and is
compliant with Intel
Connectivity Design Guide.
MSI Reminds You...
If you do not want to connect to the front audio header, pins 5 & 6, 9 & 10 have to be jumpered in
order to have signal output directed to the rear audio ports. Otherwise, the Line-Out connector on
the back panel will not function.
®
Front Panel I/O
2
1
AUD_VCC
(2)AUD_GND
(1)AUD_MIC
AUD_MIC_BIAS
10
9
8
Power Power
LED Switch
2 10
2
1 9
1
HDD Reset
LED Switch
JFP1
AUD_RET_R
Key
AUD_RET_L(10)
AUD_FPOUT_L(9)
HP_ON
AUD_FPOUT_R
Speaker
8
7
Power
LED
JFP 2