Advertisement
2.
Electrical parts (Antistatic gloves must be worn.)
Note: Remove the front panel (refer to 1. Front panel) before disassembling electrical parts.
Procedure
1) Cut the ribbon by a shear, then pull
out the coil temperature sensor (T2)
Figure 14).
(see
2) Remove one fixing screw of the
electronic control box and two screws
used for the ground connection (see
Figure 14).
3) An upward force is maintained until
the cover of electronic control box is
Figure 15).
removed (see
Note: This section is for reference only. Actual unit appearance may vary.
Illustration
Ribbon
Ground Screws
Figure
Figure 14
Figure 15
T2 Sensor
11-1
Page 7
Advertisement
