Residual Heat Indicator; Accessories - Siemens iQ700 ER9A6SD70A/08 User, Installation And Maintenance Instructions

For dual-wok burners, the inner and outer flames can
be controlled separately. The available power levels are
as follows:
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When
moving a pan support, the pan supports next to it may
also move.
Burner parts
1 Ignition plug
2 Thermocouple
3 Burner ring
4 Burner cup
5 Burner cap
Inner and outer flame on
full power.
Outer flame on low power,
inner flame on full power.
Inner flame on full power.
Inner flame on low power.
Getting to know your appliance

Residual heat indicator

Every burner on the hob has a residual heat indicator
that indicates whether it is hot or warm.
If appears in the display the burner is still hot. As the
•
burner cools down further, the display changes to
The display remains lit until the burner has cooled
sufficiently. Do not touch the respective burner if this
indicator is lit.

Accessories

Depending on the model, the hob may include the
following accessories. These can also be acquired from
the Technical Assistance Service.
--------
Code
HZ298114 Additional espresso maker grid
HZ298105 Simmer Plate
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
.
œ
Additional wok grid
Only suitable for use on wok
burners. Use cookware with a
rounded base.
To extend the service life of the
appliance, we recommend using
the additional wok grid.
Additional espresso maker
grid
Only suitable for use on the
smallest burner. Use cookware
with a diameter of less than
12 cm.
Simmer plate
This accessory part is only suita-
ble for simmering. It can be
used with the economy burner
or the standard-output burner. If
your hob has several standard-
output burners, we recommend
placing the simmer plate on the
rear or front-right standard-out-
put burner.
Place the accessory component
with the projections facing
upwards on the holder; never
place it directly on the burner.
en
11