Husqvarna TS 354XD 2022 Operator's Manual page 28

To remove the drive belt for the cutting
deck
A
C
1. Park the product on a level surface and engage
the parking brake.
2. Put the attachment lift lever in the lowest
position.
3. Remove the mandrel covers (A) and (B).
4. Remove dirt and grass clippings around
mandrels and from the top surface of the deck.
5. Turn the pulleys with your hand and pull the belt
(C) to remove it from the groove in the pulleys.
6. Remove the belt from around the electrical clutch
(D) on the engine shaft.
To install the drive belt for the cutting deck
Note:
To easily install the drive belt for the cutting
deck, refer to the routing decal on the cutting deck.
1. Make sure the deck spring (A) is attached to the
eye bolt (B) on the idler arm.
28
A
B
2. Put the belt around all pulleys except the left side
mandrel pulley.
3. Install the belt from the rear part of the left side
mandrel pulley.
4. Rotate the left side mandrel pulley to pull the belt
into the groove on the left side mandrel pulley.
5. Refer to the routing decal on the cutting deck to
make sure that the belt is installed correctly.
CAUTION:
belt is not twisted.
D
B
Make sure that the
1940 - 006 - 13.09.2022