Husqvarna TS 354XD 2022 Operator's Manual page 26

9. Install the cutting deck in the opposite sequence.
Make sure that the discharge side is on the right
side of the product. Make sure that the drive belt
for the cutting deck is installed correctly. Refer to
To remove the drive belt for the cutting deck on
page 28 .
Note:
The suspension arms must be in
forward position when you move the cutting deck
below the product.
To install the anti-sway bar
1. From the right side of the cutting deck, put the
90° end of the anti-sway bar (A) into the hole in
the transaxle bracket (B).
A
B
C
2. Put the integrated washer end (C) of the anti-
sway bar into the hole in the rear bracket on the
right side of the cutting deck. Move the cutting
deck if it is necessary.
3. Install the washer (D) and the clip (E).
To adjust the parallelism of the cutting deck
To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right
and left side of the product, the cutting height can
be adjusted. Adjust the cutting height on the side of
cutting deck that has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
Some models only have left side
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
26
E
D
A
Note:
Each full turn of lift adjustment nut
changes the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to
lower the cutting deck.
b) Turn the lift adjustment nut (A) to the right to
lift the cutting deck.
5. Cut some grass and examine the results. Adjust
if it is necessary.
To do a precision side to side adjustment of the
cutting deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 14 .
4. Turn the outer blade tips to align with the cutting
deck side to side.
WARNING:
cutting deck are sharp and can
cause injury. Use protective gloves.
5. Measure the distance (B) from the bottom edge
of the blade to the ground on the left and right
side.
B
Note:
The distance must be the same on the 2
sides.
6. Adjust the cutting height with a 3/4 in wrench.
Note:
Each full turn of the lift adjustment nut
changes the cutting height with 3/16 in (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to
lower the cutting deck.
b) Turn the lift adjustment nut (A) to the right to
lift the cutting deck.
7. Measure the distance again. Adjust until the 2
sides are equal.
The blades on the
B
A
1940 - 006 - 13.09.2022