Husqvarna TS 354XD 2022 Operator's Manual page 24

c) Carefully install the belt below around the
transmission cooling fan and onto the input
pulley (F). Make sure the belt is in the belt
keeper.
d) Install the belt on the centerspan idler (E).
e) Install the belt through the stationary idler (C)
and clutching idler (D).
f) Install the anti-rotation link (B) on the right
side of the product and tighten fully.
g) Connect the clutch harness (A).
h) Make sure the belt is in all pulley grooves and
in all belt guides and keepers.
i) Install the mower. See
the cutting deck on page 25
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove
the battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with
a wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
battery on page 12 .
To replace the battery
WARNING:
terminals. Do not let tools or other
objects touch the two terminals at the
same time.
WARNING:
battery, remove your metal bracelets,
wristwatch bands, rings, and so on.
1. Lift the hood to a raised position.
2. Remove the terminal cover (C).
3. Disconnect the black (negative) ground cable (A)
by removing the bolt and nut.
WARNING:
(negative) terminal must be
disconnected first.
4. Disconnect the red (positive) battery cable (B).
5. Carefully remove the battery from the product.
6. Install a new battery in the same position as the
old battery.
7. Install the terminal cover (C).
24
To remove and install
To connect the
Do not short the battery
Before you connect the
The black cable
8. Connect the red (positive) battery cable (B) and
tighten the bolt and nut.
WARNING:
(positive) terminal must be
connected first to prevent sparks
from accidental grounding.
9. Connect the black (negative) cable (A) and
tighten the bolt and nut.
10. Lower the hood.
C
B
To connect the jumper cables
WARNING:
because of explosive gas that comes
from the battery. Do not connect the
negative terminal of the charged battery
to or near the negative terminal of the
weak battery.
CAUTION:
your product to start other vehicles.
The red cable
A
Risk of explosion
Do not use the battery of
1940 - 006 - 13.09.2022