Additional Safety Information; Box Contents; Installation; Machine Specifications - Forney FLEX 30 PLASMA ST Operating Manual

Additional Safety Information

For additional information concerning welding safety, refer to the standards listed at the beginning of this safety
summary and comply with them as applicable.

Box Contents

Installation

Machine Specifications

Primary (Input) Volts
Phase
Frequency
Maximum Output (Welding)
Maximum Output (Cutting)
Recommended Circuit Breaker
Extension Cord Recommendations
Generator Requirements
CSA Rated Output and Duty-cycle
Dimensions
Weight
Recommended Electrode Diameter
Cutting Capacity
DESCRIPTION
ITEM
Machine
ITEM DESCRIPTION
Stick Electrode
Holder
120VAC/240VAC
Single
50/60Hz
120V – 85A (DC output only)
240V– 160A (DC output only)
120V – 20A
240V– 30A
120V – 20A time-delay (slow-blow) breaker minimum (30A for maximum performance)
240V – 30A time-delay (slow-blow) breaker minimum (50A for maximum performance)
Refer to the ratings label and set the output amperage so that the listed input amperage is not
exceeded
120V - 3 conductor #12 AWG or larger up to 25 ft.
240V - 3 conductor #10 AWG or larger up to 25 ft.
120V - Minimum 4,000W continuous output with no low-idle function (or low-idle off)
240V - Minimum 10,000W continuous output with no low-idle function (or low-idle off)
Refer to the data plate of your machine and the Duty-cycle section of this manual, page 20.
16.68" (423mm) x 8.25" (210mm) x 11.94" (303mm)
19.65 lbs. (8,62 kg)
Up to 5/32"
Cleanly cut from thin sheet metal to 3/8" plate
(Sever cut up to 5/8")
WWW.FORNEYIND.COM
ITEM DESCRIPTION
240V-120V
Adapter Cord
ITEM DESCRIPTION
Plasma Torch
ITEM DESCRIPTION
Ground Cable
and Clamp
ITEM DESCRIPTION
Additional
Set of
Consumables
13