Civco ASTRA VR Quick Start Instructions

At rest, the display reads:
Press ENTER.
Step 1:
Display will read:
Scan the barcode on the probe electrical
connector and place into the wall-mounted
Step 2:
Connector Holder.
Display will read:
Insert probe into disinfection chamber and
align blue tape on probe cable with Probe
Alignment Mark between two Probe Cable
Holders (as shown below). Slide the probe
Step 3:
cable into the Probe Cable Clip. Place probe
cable into cable holder.
Display will read:
Entering Exam ID is optional, but you must
scan ID or press ENTER to continue.
Step 4:
Display will read:
ASTRA ® VR (50230_F)
ASTRA ®
QUICK START INSTRUCTIONS
Alignment of Probe Cable
VR
Ready for Use
Press Enter to Start
Scan Probe
Insert Probe
Scan Exam ID
ENTER = skip
Close Door or
Scan Second Probe