Advertisement
GETTING STARTED
Integration must be performed by a Home Automation Integrator or licenced
technician with software and communication debugging experience.
You will need the following from Bromic
- Bromic Smart-Heat
- Bromic Heater controller (ON/OFF or Dimmer) supplied with pre-programmed paired
remote control and installed by licenced electrical contractor.
!
!
!
BROMIC ON/OFF
You will need the following supplied by others
- A compatible Home Automation system with RS232 communication port and RS232
programming interface. Refer to your Home Automation dealer for assistance with
compatibility on RS232 3rd party integration.
- Power supply +5VDC (500mA)
- RS232 cable (DB9 Male to DB9 Female connector)
- PC with COM port or USB to RS232 convertor (note you need to install the USB drivers.)
- Software installed on PC to read and send RS232 in hexadecimal codes, such as Docklight
Docklight© Disclaimer: Refer to http:\www.docklight.de for more information. Docklight© is a 3rd party software tool
developed by Flachmann und Heggelbacher with no association with Bromic. Refer to the software end licence
agreement before downloading and choosing to use this software tool. Bromic accepts no liability for the download
or use of such 3rd party software.
Link device (for Bromic Part Numbers refer to table on next page)
TM
Electrical hazard when connected to 240V AC
Electrical connections exist and potential to damage product
if incorrect polarity or short circuit.
Wireless radiation emitted by this product
TO BE INSTALLED BY ELECTRICIAN
OR
BROMIC DIMMER
bromic.com
BROMIC HEATER
REMOTE CONTROL
©
5
Advertisement
