Equity 30024, 30025 - 9-inch LED Alarm Clock, USB Charging Manual

OVERVIEW

POWER UP

1. Insert the 120 volt power cord into an outlet, then into your clock. Optional: Insert one 9 volt battery for backup.
2. 12:00 will flash as an indication to set the time and/or alarm.

TIME SETTING

1. Continuously hold down the TIME button, then:
   • Press the HOUR button to set your hour.
   • Press the MINUTE button to set your minutes.
     Note: The PM indicator will appear when you advance to PM time.
2. Release the TIME button when the correct time is shown on the display.

BACKLIGHT

Your backlight has three levels: High, Low, and Off.

• Press the SNOOZE/LIGHT button to adjust.

USB CHARGING PORT

• Connect your external device's USB charging cable (not included) to the USB charging port.
• USB Power Output: 5V 1A maximum current.
• Charge devices that are self-regulating.

TIME ALARM

1. Continuously hold down the ALARM button, then:
   • Press the HOUR button to set your hour.
   • Press the MINUTE button to set your minutes.
     Note: The PM indicator will appear when you advance to PM time.
2. Release the ALARM button when the correct alarm time is set.

ALARM ON/OFF

ON: Slide the ALARM ON/OFF switch to the ON position to turn the alarm ON. The alarm light indicator will appear.

OFF: Slide the ALARM ON/OFF switch to the OFF position to turn the alarm OFF. The alarm light indicator will disappear.

SNOOZE

• When the alarm sounds press the SNOOZE/LIGHT button to silence the alarm for 10 minutes.
• Snooze may be repeated.

Note: This is a Ascending alarm. It will sound with increased frequency for 2 minutes then shut off if no buttons are pressed.

BATTERY BACKUP

• Insert one "9V" battery into the battery compartment on the back of the clock. The battery will keep the alarm and time settings until the power is restored.
• The LED display will not light-up but the alarm will sound at the preset alarm time.
• If there is no battery installed but the power is interrupted, the display will flash at 12:00 and the time and alarm need to be set again.

CARE & MAINTENANCE

• Always purchase the correct size and grade of battery most suitable for intended use.
• Clean the battery contacts and also those of your clock prior to battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from equipment when it is not used for an extended period of time.
• Promptly remove an expired battery.

POWER REQUIREMENTS

Power: 120V power cord
Requires one 9V battery for back-up not included

Dimensions: 5.00 "W x 2.00"D x 2.85"H