aus Troubleshooting
Fault
Detergent residue is present
in the detergent dispenser
or the tablet collecting tray.
Excessive formation of foam
occurs.
Home Connect problem
Fault
Connection to home net-
work is not established.
WLAN display is flashing.
Home Connect cannot be
implemented correctly.
Information on display panel
Fault
Refill indicator for rinse aid
lights up.
Refill indicator for rinse aid
does not light up.
Malfunctions
Fault
Water is left in the appliance
at the end of the pro-
gramme.
52
Cause
Detergent dispenser was
damp when detergent was
added.
Hand washing-up liquid is
present in dispenser for
rinse aid.
Rinse aid has been spilled.
Detergent or appliance care
product used causes excess-
ive foaming.
Cause
WLAN on router is not act-
ive.
Connection to home net-
work is not available.
Home Connect set incor-
rectly.
Technical fault is present.
Cause
Insufficient rinse aid.
Rinse aid system is switched
off.
Cause
Filter system or area under
the filters is blocked.
Troubleshooting
Only add detergent to a detergent
▶
dispenser when dry.
Immediately add rinse aid to the
▶
dispenser.
→ "Adding rinse aid", Page 28
Remove the rinse aid with a cloth.
▶
Change the brand of detergent.
▶
Troubleshooting
Check the wireless network con-
▶
nection of your router.
Activate the wireless network con-
▶
nection on your router.
Please consult the documents sup-
▶
plied for Home Connect.
Please consult the information
▶
about support in the documents
supplied for Home Connect.
Troubleshooting
Add "Rinse aid" → Page 28.
1.
Set the amount of rinse aid to be
2.
dispensed.
→ "Setting the amount of rinse aid",
Page 29
Set the amount of rinse aid to be
▶
dispensed.
Troubleshooting
Clean the "Filters" → Page 41.
1.
Clean the "Wastewater pump"
2.
→ Page 55.