Table of Contents
Advertisement
Fault
Removable streaks are
present on glasses, glass-
ware with a metallic appear-
ance and cutlery.
Irreversible clouding of
glassware.
Rust spots on cutlery.
Detergent residue is present
in the detergent dispenser
or the tablet collecting tray.
Cause
Amount of rinse aid to be
dispensed is set too high.
No rinse aid has been ad-
ded.
Detergent residue is present
in the final rinse. Lid of the
detergent dispenser is
blocked by tableware items
and will not open fully.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
Glasses are not dishwasher-
proof, only suitable for dish-
washers.
Cutlery is not sufficiently
rust-resistant. Knife blades
are often more severely af-
fected.
Cutlery may also rust if
washed together with rust-
ing items.
Spray arms were blocked by
tableware so detergent was
not rinsed out.
Troubleshooting aus
Troubleshooting
Set the rinse aid system to a lower
▶
setting.
→ "Adding rinse aid", Page 28
▶
Arrange tableware in the top basket
1.
tableware so the tab collecting tray
is not obstructed by tableware.
→ "Arrange tableware", Page 33
Items of tableware are blocking the
dispenser lid.
Do not place tableware or fra-
2.
grance dispensers in the tablet col-
lecting tray.
Only remove large remnants of food
▶
and do not prerinse tableware.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 13
Use dishwasher-proof glasses.
▶
Glasses are usually only suitable for
use in a dishwasher, i.e. long-term
wear or long-term changes must be
expected.
Avoid a lengthy steam phase
▶
(standing time after wash cycle
ends).
Use a programme with a lower tem-
▶
perature.
Use detergent with a glass protec-
▶
tion component.
Use rust-resistant tableware.
▶
Do not wash rusting items.
▶
Check that the spray arms are not
▶
blocked and can rotate freely.
51
Advertisement
Table of Contents
