GE PTD90EBMTRS Owner's Manual page 18

Troubleshooting Tips... Before you call for service
Problem
Water drips Steam and fabric refresher
from door when condenses on inner door
opened after a
Fabric Refresh tank is loose
Steam or Fabric
or not fully seated in its
Refresh cycle
compartment
Cannot see Steam and fabric refresher
steam or fabric are released at different times
refresher at during the cycle
beginning of
cycle
Cannot see The steam nozzle might be
steam during clogged with debris from your
cycle water supply
Fabric Refresh Fabric Refresh door not
Door Open closed properly
displayed
Garments with Too many garments
no perceptible
refresher scent
after Fabric
Fabric Refresh tank is empty
Refresh cycle
The Fabric Refresh nozzle
might be clogged with lint
The Fabric Refresh nozzle
might be clogged with lint or
debris from liquid sediments
18
Possible Causes What To Do
This is normal.
Ensure the tank is placed correctly and firmly seated to the bottom
of its compartment
This is normal.
Call GE Appliances at 877.959.8688 to order steam nozzle
replacement kit WE25M71 or to request a technician to replace
this for you.
Verify that the Fabric Refresh door is closed before running a
cycle. If the Fabric Refresh door is not properly and fully closed the
dryer will sense an improper door connection.
Load fewer garments or increase the drying time.
Select the More setting in cases where Less or Auto where
previously selected.
Verify that tank has enough liquid to ensure a proper dosing in a
cycle.
Remove the lint from the nozzle.
Call GE Appliances at 877.959.8688 to order Fabric Refresh
nozzle replacement kit WE01X34098 or to request a technician to
replace this for you.
49-3000244 Rev 5