Electrical Safety; Assembly And Adjustments - Black & Decker BEPW1300 Manual

ENGLISH
Labels on tool
The following symbols are shown on the tool along with the
:
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
f
Wear eye protection.
g
Wear ear protection.
Machine not suitable for connection to the potable
water mains.
Directive 2000/14/EC guaranteed sound power.
92
BEPW1300
Directive 2000/14/EC guaranteed sound power.
91
BEPW1700
Directive 2000/14/EC guaranteed sound power.
93
BEPW2000
#

Electrical safety

This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
Voltage drops (only for BEPW2000)
Inrush currents cause short‑time voltage drops. Under
unfavourable power supply conditions, other equipment may
be affected. If the system impedance of the power supply is
lower than 0.378 Ω, disturbances are unlikely to occur.
Features (Fig. A)
1. High pressure hose
2. Spray wand
10
(Original instructions)
Never direct the water
jet at people, animals,
the machine or electric
components
3. Nozzle button
4. Spray handle
5. Spray handle grip
6. Trigger lock‑off
7. Trigger
8. Spray fan to pencil jet nozzle
9. Hose connector
10. Filter
11. Soap bottle
12. Soap bottle applicator
13. Hose connect button
14. Nozzle cleaning tool
15. Turbo nozzle (BEPW2000)
16. Pressure washer unit
17. ON/OFF dial
18. Handle
19. Retractable handle (BEPW1700, BEPW2000)
20. High pressure water outlet
21. Cord retaining hook
22. Power cord
@

Assembly and Adjustments

WARNING: Before attempting any of the following
operations, make sure that the tool is switched off
and unplugged.
Attaching Spray Handle (Fig. B)
1. To connect the spray handle ( 4 ) to the spray wand ( 2 ),
insert the end of the spray handle onto the end of the
spray wand.
2. Press in and turn the spray handle counterclockwise to
lock it into position.
Attaching High Pressure Hose (Fig. C)
NOTICE: Never pull high pressure hose or water
supply hose to move pressure washer. This could
damage hose and/or pump inlet and/or pump outlet.
1. To connect the high pressure hose ( 1 ) to the
spray handle ( 4 ), depress the hose connect button ( 13 )
while clicking the hose end ( 23 ) into the spray handle.
Release the hose connect button when the hose end has
clicked into position.
2. To connect the high pressure hose to the pressure washer
unit ( 16 ), screw the hose collar ( 24 ) onto the high
pressure water outlet ( 20 ).
NOTE: Uncoil the high pressure hose before installation to
prevent kinks.
NOTE: Avoid cross threading when installing the hose.
Cross threading will cause leaks.