This instruction sheet tells how to install your EP-25 Speed sensor and
connect it to a NMEA 2000
components. You must refer to your digital gauge, sonar or GPS unit's
manual for sensor operation instructions.
Caution:
Installing LowranceNET NMEA 2000 devices is significantly
different from installing earlier Lowrance components without
NMEA 2000 features. You should read all of the installation
instructions before proceeding. You should decide where to
install all components before drilling any holes in your vessel.
Some sonar or GPS units may require a software upgrade to display
NMEA 2000 data correctly and a manual addendum describing how to
operate the sensor. You can download these free and get additional
information on the NMEA 2000
our web site, www.lowrance.com.
All Lowrance NMEA 2000 capable devices are either NMEA 2000
certified or certification is pending. See our web site for the latest
product status information.
Smart module
The EP-25 consists of the paddle wheel module, a blue female locking
cable connector and the smart module. The cable length from the
EP-25 Speed
Electronic Sensor
Installation Instructions
The EP-25 Speed sensor.
network using LowranceNET network
compatible LowranceNET system at
Paddle wheel module
1
Pub. 988-0154-451
Blue female NMEA
2000 connector