Serial Communication Setup; Reset Options - Lowrance 100 Installation And Operation Instructions Manual

If you have any other Magnavox or Starlink compatible
DGPS receiver connected to the AirMap 100, you may
need to change the settings. To do this, move the black
box to the "Configure DGPS" label and press the right
arrow key. A screen similar to the one at right appears.
These menus select the beacon receiver's frequency
and bit rate (in bits per second). To change one of these
settings, simply highlight the menu item you wish to
change, then press the right or left arrow key until the
desired number appears.
The "STAR AUTO" menu works with the Starlink or compatible receivers
that automatically determine the frequency and bit rate. If you have one of
these receivers, leave this set to "ON".
Press the EXIT key when you're finished.

Serial Communication Setup

If you're connecting a computer or other serial device
to this unit, (including DGPS receivers) you'll probably
need to change the communications settings. To do
this, select "COM PORT SETUP" on the System Setup
menu. Press the right arrow key. The screen shown at
right appears.
Check your computer or DGPS receiver's manual for
the proper data settings. Highlight the menu item you
need to change. Press the left or right arrow keys to
change them. The serial port defaults are 4800 baud,
no parity, and 8 data bits. Press the EXIT key to erase this menu.

Reset Options

To return the unit to the original factory settings, highlight the "RESET
OPTIONS" menu on the System Setup screen. Now press the right arrow
key. A message appears, asking if you want to restore the original op-
tions. Press the right arrow key if you do, the left arrow key to quit.
If you restore the unit to the factory settings, all options such as contrast,
alarms, and other system choices are returned to their default values.
However, no waypoints, routes, or icons are erased.
60